Refrigerator System Service Valves

When servicing or commissioning any equipment it is necessary to record the system pressures by fitting pressure gauges. To make this possible, all commercial systems generally include at least three service valves: suction, discharge and liquid shut-off.

Suction and discharge service valves may be located on the compressor body of both reciprocating open-type compressors and semi-hermetic motor compressors, but on some compressor designs the service valves may be an integral part of the compressor head assembly. Hermetic motor compressors and some semi-hermetic models do not feature a discharge service valve, but the high side pressure may be obtained from the service valve on the liquid receiver or via a Schraeder-type valve fitted into the discharge line or on the receiver itself. Service valves can be set to three different positions (Figure 3):

Service valve
Service valve

Front seated position The valve stem is turned fully clockwise to effectively stop the flow of refrigerant vapour from the suction line union on the low pressure side of the compressor and to the discharge line union on the high pressure side of the compressor. Back seated position The valve stem is turned fully counter-clockwise to stop the flow of refrigerant vapour to the gauge port of the service valve. Midway position The valve stem is turned either clockwise or counterclockwise to leave the valve unseated. Thus refrigerant vapour can flow from the suction line and also to the discharge line and at the same time pass through the gauge port, to the gauge hose and to the relevant pressure gauge.

The liquid shut-off valve may be located at the outlet of the receiver. It is a single seating valve, i.e. it is either open or closed (Figure 4). On systems which do not have a receiver the valve design will be similar to that of a suction or discharge service valve and will have a gauge connection. When closed or fully front seated, this valve will stop the flow of liquid refrigerant from the condenser or receiver to the expansion device.

Performing service operations, carrying out repairs, commissioning a system and diagnosing faults involve the use of these valves in addition to test equipment, which will be dealt with separately.

Typical receiver valve
Typical receiver valve

 

2 Replies to “Refrigerator System Service Valves”

  1. I am looking for those twist-on on refrigerator service valves used to evacuate and charge the system after replacing the evaporator and/or compressor. Said service valves are installed temporarily onto the end of the tubing (without brazing) and later removed after tubing has been pinched-off (and tubing end then sealed by brazing.)

    Thank you in advance for your response.

  2. jago4it@yahoo.com is the right email address.

    I am looking for those twist-on on refrigerator service valves used to evacuate and charge the system after replacing the evaporator and/or compressor. Said service valves are installed temporarily onto the end of the tubing (without brazing) and later removed after tubing has been pinched-off (and tubing end then sealed by brazing.)

    Thank you in advance for your response.

Leave a Reply

Your email address will not be published. Required fields are marked *