1 Power supply disconnected. 2 Bin thermostat contacts stuck open. 3 Master switch left in ‘Clean’ position. 4 Defective relay. 5 Defective compressor motor. 6…

1. Hot gas bypass solenoid stuck open. 2. Leak in the sealed system. 3. Water supply faucet turned off. 4. Water float inoperative. 5. Water…

A. After the unit is disassembled, check all the parts for wear and discard worn parts. Replace bad parts with new, authorized parts only. (See…

1. Place shaft seal mount-over gear motor output shaft and push down until shaft seal mount rests flush on top of gear motor. 2. Place…

1. Disconnect unit from power supply. 2. Remove storage container cover and put aside. 3. Turn off water supply to ice maker. 4. After ice…

The purpose of the water-level control is to automatically maintain proper water level in the ice flaker. Proper water level should be horizontal with the…

1. Donut-shaped ice cubes 2. Hissing sound heard in the evaporator while running If ice cubes come out too thin or too thick, the reason…

When the solenoid valve is energized by a timer, it opens, allowing some of the hot gas to circulate though the tubing. On the way…