3. REED S/W
Remove screw
Unplug Refrigerator, or disconnect power at the circuit
breaker. If necessary, remove top shelf or shelves.
1. Use a flat blade screwdriver to release the 3 hooks of the
cover LED under the direction of each hook (refer Fig. 1)
When removing the cover LED, be careful that
the cover does not get broken.
• Upper LED Refrigerator
CAUTION:
Disassemble Housing
Check Resistance of Reed S/W. if it is NG, change it
(Number3)
Assemble Reed S/W to hinge cover and Assemble Reed S/W
housing.
Assemble Screw to hinge cover.
4. REMOVING AND REPLACING
REFRIGERATOR AND FREEZER LEDs
Push Hook
Push first
Push second
2. Using a phillips screwdriver remove 2 screws from the
case LED as shown in the pictures.
3. Disconnect the wire LED and remove it.
NOTE: To reinstall the LED repeat the same steps but in the
opposite order.